Difference between revisions of "Netband Project - Multicast"
From Teknologisk videncenter
(→Configuration) |
(→Configuration) |
||
| Line 34: | Line 34: | ||
description HQSW1 | description HQSW1 | ||
ip address 10.255.255.2 255.255.255.252 | ip address 10.255.255.2 255.255.255.252 | ||
| − | ip pim sparse-mode | + | ip pim sparse-dense-mode |
ip nat inside | ip nat inside | ||
ip virtual-reassembly | ip virtual-reassembly | ||
| Line 43: | Line 43: | ||
! | ! | ||
</pre> | </pre> | ||
| + | |||
==Verification== | ==Verification== | ||
<pre>B1sw1#sh ip mroute | <pre>B1sw1#sh ip mroute | ||
Revision as of 09:19, 29 April 2009
This page is part of the Netband Project
- A multicast server is installed on the server HQDC1
Configuration
- Switch
ip multicast-routing distributed ! interface FastEthernet0/24 description HQrt1 no switchport ip address 10.255.255.1 255.255.255.252 ip pim sparse-mode ip ospf network point-to-point ip ospf dead-interval minimal hello-multiplier 4 ! interface Vlan3 ip address 10.1.1.1 255.255.255.0 ip pim sparse-dense-mode ! ip pim rp-address 10.0.0.12
- Routers
ip multicast-routing ! interface Tunnel0 ip address 10.255.254.1 255.255.255.252 ip mtu 1300 ip pim sparse-dense-mode ip virtual-reassembly tunnel source Loopback1 tunnel destination 10.255.253.2 ! interface FastEthernet0/1 description HQSW1 ip address 10.255.255.2 255.255.255.252 ip pim sparse-dense-mode ip nat inside ip virtual-reassembly ip ospf network point-to-point ip ospf dead-interval minimal hello-multiplier 4 duplex auto speed auto !
Verification
B1sw1#sh ip mroute
(10.1.1.11, 239.0.0.40), 00:11:05/00:02:54, flags: JT
Incoming interface: FastEthernet0/2, RPF nbr 10.255.255.14
Outgoing interface list:
Vlan5, Forward/Sparse, 00:11:05/00:02:48